Filling Out Labels - AT&T MLC-6 Installation And Troubleshooting Manual

Filling Out Labels

Using a ball-point pen or pencil only, write the following
information on the erasable labels and directory card:
On the labels above and below the
handset display, first peel off
the protective plastic overlay,
then write line numbers or
programmed features assigned to
each of the outside line/pro-
grammable buttons. See the above
illustration and Quick Reference:
Controls and Displays.
On the handset extension label
(below the mouthpiece) and on the
base extension label, write the
phone's extension number.
NOTE:
If you use a pencil or ball-point pen on these labels, you will be
able to erase the information later. Do not use felt-tip or other
types of non-erasable markers. Also, do not remove the labels.
16
On the directory card, write any
important phone numbers, exten-
sion numbers, or Speed Dial
numbers you may want to have as
a reference. The directory card is
beneath the cover that contains
user instructions, on the top back
of the handset (behind the an-
tenna). To open the cover, push up
on the dots on the cover until the
cover locks into place.