Removing The Stand; Setting The Tv On The Wall - Sharp LC-C5262U Service Manual

Appendix

Removing the stand

Before detaching (or attaching) stand, unplug the AC cord from the AC INPUT terminal.
CAUTION
Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
Before performing work make sure to turn off the TV.
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
1
Unfasten the four screws used to secure the stand in
place.
NOTE
To attach the stand, perform the above steps in reverse order.

Setting the TV on the wall

CAUTION
This TV should be mounted on the wall only with the AN-52AG1 (SHARP) wall mount bracket. The use of other
wall mount brackets may result in an unstable installation and may cause serious injuries.
Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or
mounting that results in accident or injury.
Using an optional bracket to mount the TV
You can ask a qualified service professional about using an optional AN-52AG1 bracket to mount the TV to the
wall.
Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-52AG1 wall mount bracket.
Vertical mounting
NOTE
Detach the cable clamps on the rear of the TV when using the optional mount bracket.
Hex key
About setting the TV angle and height adjustment
Angular mounting
2 – 3
2
Detach the stand from the TV.
(Hold the stand so it will not drop from the edge of the
base area.)
Angle of TV 0/5/10/15/20°
Height
1 / ( 5)/0/
63
64
Adjustment 1 / ( 5)
63
64
can be moved 1
(5) up or down
Unit: inch (cm)
LC-C4662U/LC-C5262U
/
63
64