Safe Finish Wiring Diagrams; Optional Pneumatic Door Edge Installation - Allstar LT 50 Installation And Owner's Manual

SAFE FINISH WIRING DIAGRAM / DOOR EDGE INSTALLATION
SAFE FINISH PHOTOSYSTEM WIRING - MODEL LT 50
109985

OPTIONAL PNEUMATIC DOOR EDGE INSTALLATION

In some situations a pneumatic door reversing edge may be used to detect obstructions in order to to comply with code requirement IN
ADDITION TO the installation of Allstar's Safe Finish Photosystem. A pneumatic door edge will only work with the LT 50 operator
if a Safe Finish Photosystem has been installed on the door and connected to the operator, and the motor control board configured for
Safe Finish operation (see page 11 and 12). Follow the installation diagram below and any instructions that may be provided by the
door manufacturer to install a pneumatic door edge.
Connect the wires from the air switch to Terminals 4 and 5 on the operator's rear panel (see page 19 for illustration of the rear panel
terminals).
20