Preparation Of The Remote Control - Toshiba XS35 - RD - DVDr Owner's Manual

Introduction

Preparation of the remote control

1
Open the cover.
2
Insert batteries (AAA size).
Make sure to match the + and – on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
18
Downloaded from www.Manualslib.com manuals search engine
Caution
• Never throw batteries into a fire.
Notes
• Dispose of batteries in a designated disposal area.
• Attention should be drawn to the environmental aspects of
battery disposal.
• Do not mix different battery types or combine used
batteries with new ones.
• If the remote control does not operate correctly, or if the
operating range becomes reduced, replace both batteries
with new ones.
• If the batteries are dead or if you will not be using the
remote control for a long time, remove the batteries to
prevent battery acid from leaking into the battery
compartment.
Operating with the remote control
Point the remote control at the remote sensor and
press the buttons.
Distance : About 7 m (23 ft) from the front of the
remote sensor
Angle : About 30° in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the recorder to a
strong light source such as direct sunlight or other
illumination. If you do so, you may not be able to
operate the recorder via the remote control.
Notes
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or
humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
30°
30°
Within about 7 m (23 ft)