Safety Instructions - Neoware e140 - Thin Client User Manual

Safety Instructions

Please read these safety instruction carefully and keep this user's manual for later refer-
ence.
1
Before removing the outer case from the appliance always disconnect the AC power cord to pre-
vent the possibility of dangerous electrical shock.
2
Before cleaning, disconnect the appliance from AC power. Do not use liquid or sprayed cleaning
products to clean the unit. Instead, use a moistened sheet or cloth for cleaning.
3
Be sure not to expose the appliance to excessive humidity.
4
Be sure to install the appliance on a secure surface. A falling appliance could cause injury.
5
Place the power cord in such a way to avoid people stepping on it. Do not place anything over
the power cord.
6
Be sure to note all cautions and warnings on the appliance.
7
If the appliance is not used for a long period of time, disconnect the AC power to avoid damage
caused by voltage transients.
8
Never pour any liquid into any appliance openings: This could cause fire or electrical shock.
9
If one of the following situation occurs, be sure to get the appliance checked by a qualified ser-
vice technician:
a. The power cord or plug is damaged.
b. Liquid penetrates the appliance case.
c. The appliance is exposed to moisture.
d. The appliance does not work well or you cannot get it to work according to the user's man-
ual.
e. The appliance has been dropped or damaged.
f. If the appliance has obvious signs of breakage.
10
The appliance should be stored and used only in temperature and humidity controlled environ-
ments. Storing appliances below -20°C (-4°F) or above 60°C (140°F) may cause damage.
11
The sound pressure level at the operators position according to IEC 704-1:1982 is equal or less
to 70dB(A).
12
The input power cord shall be minimum H05VV-F, 3G, 0.75mm², rate minimum 6A.
13
The appliance should be used only where ambient air temperatures are maintained below 40°C.
iv Safety Instructions