Factory Reset The Thin Client; Power Off The Thin Client; Insert The Usb Wireless Ethernet Adapter's; Power On The Thin Client - Neoware e140 - Thin Client User Manual

Factory reset the
thin client
Power off the thin
client
Insert the USB
Wireless Ethernet
Adapter's USB
connector
Power on the thin
client
TIP
Configure the display to
1024x768 or higher
resolution for easiest
interaction with the
Network Settings dia-
log.
Configuring the Neoware 802.11b USB Wireless Ethernet Adapter
If the thin cli-
ent to which
the USB Wire-
less Ethernet
Adapter is
being attached
has previ-
ously been
used with a
wired Ether-
net LAN (10
BaseT or 100
BaseT), first factory reset the thin client before attaching the thin cli-
ent. From the ezConnect screen, select
tings | Appliance properties
been set, it will be required before the factory reset can be accom-
plished.
After the thin client beeps during the factory reset reboot, use the
power switch to turn the power off.
While the power is turned off, insert the USB connector from the
Wireless Ethernet Adapter into one of the thin client's available USB
ports.
Use the power switch to turn the thin client on with the Wireless
Ethernet Adapter plugged in to one of the USB ports.
Configuring Your Network Settings
Factory Reset
menu. If a configuration password has
Set-
from the
35