Advertisement
INSTALLATION
PROCEDURES
When first powering up a Windows 2000 operating system with an Altos S300
enclosure attached, Windows 2000 will launch the "Found New Hardware
Wizard". This wizard requires the installation of a suitable device driver for the
attached enclosure(s). The device driver should be installed by following this
procedure:
Install Altos S300's Device Driver
1.
Attach the enclosure(s) to a Windows 2000 system as described
previously.
2.
Boot the system and log in (with Administrator privileges).
3.
The "Found New Hardware Wizard" will launch for each ES block
detected in the attached enclosure(s). For each of these, perform the
following steps:
a.
Click 'Next'
1
Installation Guide for Altos S300's Device Driver
Advertisement
