2.10 Starting The Advanced Hybrid System - Panasonic KX-TA82492 - Voice Message Expansion Card Installation Manual

2.10 Starting the Advanced Hybrid System

2.10.1 Starting the Advanced Hybrid System
This section explains the procedure for starting the PBX for the first time, with default values, or when
you wish to re-initialize the PBX.
1.
Make sure that all outside (CO) lines you use are connected to the PBX.
2.
Set the Power Switch to the "OFF" position.
3.
Connect the AC cord to the PBX, then plug the AC cord into an AC outlet.
4.
Set the Power Switch to the "ON" position.
Note
For safety reasons, do not stretch, bend, or pinch the AC cord.
To AC Outlet
5.
Perform the following operation with a proprietary telephone (PT) connected to JACK 01.
a.
Press the PROGRAM button.
b.
Press
c.
Enter 1234.
d.
Enter 999.
e.
Press the NEXT (SP-PHONE) button.
f.
Press the SELECT (AUTO ANS/MUTE) button until "All Para" is displayed.
g.
Press the STORE (AUTO DIAL/STORE) button.
h.
Press the END (HOLD) button.
i.
Press the PROGRAM button.
• The PBX will be initialized with the default values. The type of outside (CO) lines is
automatically detected.
• If the PBX does not function properly, refer to "4.1.5 System Reset with System Data Clear".
6.
Program the PBX using either one of the following methods:
a.
PC programming. Refer to "Section 3, Guide for KX-TA Maintenance Console".
b.
PT programming. Refer to "2 PT Programming" of the Programming Manual.
Power Switch
AC Cord
#.
2.10 Starting the Advanced Hybrid System
Installation Manual 67