2.8 Connecting Peripherals
the MOH Jack of the PBX.
Use an EIAJ RC-6701 A plug (2-conductor, 3.5 mm [1/8 in] in diameter).
Input impedance: 8 Ω
•
CAUTION
•
Do not force audio cables into the jacks. Doing so may damage the connections and cause
the audio to cut in and out.
•
The MOH port is an SELV port and should only be connected to an approved SELV device.
Notes
•
Use the supplied audio source connector in the event that the user-supplied audio cable
connector is too long and does not fit when the top front cover of the PBX is closed. Remove
the connector from the user-supplied audio cable, expose the bare cable, and attach the
supplied audio source connector.
•
When the PBX and external audio source are not connected to the same ground, a humming
noise may be heard in the BGM and MOH.
•
The audio source used for BGM and MOH is determined by system programming.
•
To adjust the sound level of the MOH, use the volume control on the external audio source.
Feature Manual References
1.1.7 Background Music (BGM)
1.1.85 Music on Hold
Pager
Only 1 paging device (user-supplied) can be connected to the PBX.
Use an EIAJ RC-6701 A plug (2-conductor, 3.5 mm [1/8 in] in diameter).
Output impedance: 600 Ω
•
CAUTION
The External Paging Jack is an SELV port and should only be connected to an approved SELV
device.
Notes
•
Use the supplied pager connector in the event that the user-supplied pager cable connector
is too long and does not fit when the top front cover of the PBX is closed. Remove the
connector from the user-supplied pager cable, expose the bare cable, and attach the
supplied pager connector.
•
To adjust the sound level of the pager, use the volume control on the loudspeaker or
amplifier.
Feature Manual References
1.1.92 Paging—SUMMARY
62
Installation Manual