Installing The Tape Blade, Partnered With A Half-Height Server Blade; Removing The Connector Cover - HP EH920A - StorageWorks Ultrium 1760 Tape Drive User Manual

Figure 7 Removing the connector cover
CAUTION:
To prevent damage to the backplane connector, take special care when handling the tape
blade assembly. If the tape blade is installed with a damaged connector, the enclosure
backplane may also be damaged.
5.
Install the tape blade, ensuring that it is in the correct orientation: in a c7000 enclosure the latch is
at the bottom of the blade assembly, as illustrated; in a horizontal orientation in a c3000 enclosure it
is to the right of the tape blade. Carefully push the tape blade into the device bay (1) and push
the latch in (2) to secure the blade in position.
CAUTION:
Take care as you push the blade into position. Do not press directly on the cassette door,
because this may damage it.
Figure 8 Installing the tape blade, partnered with a half-height server blade
6. Now go to "Powering the tape blade on and off" on page 28.
23
Tape Blade