Installing The Remote Control Battery - Bose Wave Radio CD Owner's Manual

Setting Up

Installing the remote control battery

Figure 5A or 5B
Installing the battery
8
WARNING: Mishandling the remote control battery may cause a fire or chemical burn. Keep
the battery away from children. Do not recharge, disassemble, heat above 212˚F (100˚C), or
incinerate the battery. Dispose of the used battery promptly and responsibly.
Your remote control battery may already be installed. If you need to install or replace the
battery follow the instructions below:
Your remote control may be one of two types (Figure 5A or 5B). Each is identified by the way
the battery compartment unlocks.
1. Place the remote control face down on a flat surface.
2. If your remote has a slot on the back (Figure 5A), follow step A. Otherwise, follow step B
and refer to Figure 5B:
A. Insert the tip of a ballpoint pen into the slot. Push to the side as shown and hold. Slide
the battery compartment open with your finger (and, if necessary, remove the battery).
B. Using your finger, push the tab lock to the side as shown and hold. Slide the battery
compartment open (and, if necessary, remove the battery).