Text Messages - IBM 8670M1X User Manual

Sometimes the first error to occur causes additional errors. In this case, the server
displays more than one error message. Always follow the suggested action
instructions for the first error message that appears.
The following sections contain the error codes that might appear in the detailed test
log and summary log when the diagnostic programs are run.
The error code format is as follows:
fff-ttt-iii-date-cc-text message
where:
fff
ttt
iii
date
cc
text message is the diagnostic message that indicates the reason for the problem.

Text messages

The diagnostic text message format is as follows:
Function Name: Result (test specific string)
where:
Function Name
Result
is the three-digit function code that indicates the function being
tested when the error occurred. For example, function code 089 is
for the microprocessor.
is the three-digit failure code that indicates the exact test failure that
was encountered. (These codes are for trained service personnel;
see "Diagnostic error codes" on page 88).
is the three-digit device ID. (These codes are for trained service
personnel; see "Diagnostic error codes" on page 88).
is the date that the diagnostic test was run and the error recorded.
is the check value that is used to verify the validity of the
information.
is the name of the function being tested when the error occurred. This
corresponds to the function code (fff) shown in the error code format in the
previous section.
can be one of the following:
Passed
Failed
User Aborted
Not Applicable
Aborted
Warning
This result occurs when the diagnostic test
is completed without any errors.
This result occurs when the diagnostic test
discovers an error.
This result occurs when you stop the
diagnostic test before it is complete.
This result occurs when you specify a
diagnostic test for a device that is not
present.
This result occurs when the test could not
proceed, for example, because of the
system configuration.
This result occurs when a possible problem
Chapter 3. Diagnostics
29