Brother BE-901 Head Board Replacement page 2

4. Unplugging all wire connector harnesses. P1, P2, P3, P4, P5, P6, P7, P8, P9, P10, P11
and P12.
5. Unplug all connectores to remove board. However, keep in mind that connectors only
go in one spot and can not be confused.
6. Board is held inplace by plastic clip locks. In order to unlock you will need to squeese
locks and lightly pull-up on board to release.
(Fig. 1-1)
plastic clip locks
2
Four-clip locks
hold board down.
plastic clip locks