2.6.2 Hard disk drive installation
The detachable hard disk drive cage can accommodate one IDE or
Serial ATA hard disk drive.
To install an IDE hard disk drive:
Configure your hard disk drive as Master/Slave device before installing
it to the drive cage. Refer to the HDD documentation on how to set the
drive as a Master/Slave device.
1. Press the HDD cage lock while
pulling the cage out from the
chassis. Place the HDD cage in
a flat surface.
DO NOT install a hard disk drive to the lower bay of the cage.
3
3. Secure the HDD to the cage
with two screws (with metal
washers) on both sides of the
cage.
ASUS AP120-E1 user guide
1
2
2. Insert a HDD to the upper bay
of the cage. Make sure that the
HDD screw holes are aligned
with the HDD cage screw holes
(with black rubber stoppers).
4. Re-install the HDD cage to the
chassis. Align the HDD cage
and bay assembly rails, then
carefully push the HDD cage
until it is flushed to the chassis.
Screw holes
4
2-11