White Balalace (White Bal.); Backlight; Ssnr - Samsung iPolis SND-460V User Manual

Ch5. How to Operate Camera

5.2.3. WHITE BALALACE (WHITE BAL.)

Use the White Balance function to adjust the screen color.
1. When the SETUP menu screen is displayed, select 'White Bal.' by using the Up and
Down buttons so that the arrow indicates 'White Bal.'.
2. Select a desired mode using the Up and Down buttons.
MAIN SETUP
1.LENS
2.EXPOSURE
3.WHITE BAL

4.BACKLIGHT

* Select one of the following 5 modes, as appropriate for your purpose.
• ATW : Select this when the color temperature is between 1800°K and 10500°K.
• INDOOR : Select this when the color temperature is between 4500°K and 8500°K.
• OUTDOOR : Select this when the color temperature is between 1800°K and 10500°K.
(sodium light inclusion)
• AWC → SET : To find the optimal setting for the current luminance environment in this
mode, set the point the camera towards a sheet of white paper and press
the SET button. If the environment changes, readjust it.
• MANUAL : Select this to fine-tune White Balance
manually. Set White Balance first by using
the ATW or AWC mode. After that switch
to MANUAL mode, fine-tune the White
Balance and then press the SET button.
Notes
White Balance may not work properly under the following conditions. In this case select the AWC mode.
• When the color temperature of environment surrounding the subject is out of the control range (e.g. clear sky,
or sunset)
• When the ambient illumination of the subject is dim.
• If the camera is directed towards a fluorescent light or is installed in a place where illumination changes
dramatically, the White Balance operation may become unstable.
62
NETWORK CAMERA
DC
ATW
OFF
User's Manual
5.2.4. BACKLIGHT
This camera is designed so that it delivers a distinctive subject and background at the
same time, even when the subject is in backlight, unlike conventional cameras, by
adopting a proprietary W-IV DSP chip.
1. When the SETUP menu screen is displayed, select 'BACKLIGHT' by using the Function
Setup switch so that the arrow indicates 'BACKLIGHT'.
MAIN SETUP
1.LENS
2.EXPOSURE
3.WHITE BAL
4.BACKLIGHT

5.SSNR

2. Select a desired mode using the Function Setup switch depending on the camera
purpose.
BLC : Enables a user to directly select a desired area from a picture, and to view the
area more clearly.
BLC
HLC (High Light Compensation) :
If there is a high light installed in a limited environment such as an apartment
parking garage or gas station entrance, removing the high light makes it possible to
view car license plates efficiently.
- DAY : In normal daylight conditions, the HLC is not activated.
- NIGHT : If a high light that is larger than a certain size is present on the screen,
remove the high light to see license plates clearly.
NETWORK CAMERA
DC
ATW
OFF
ON
OFF
63
User's Manual