KitchenAid KSSC42QTS - 42" Refrigerator Installation Manual page 23

4. Slide the backer panel into the top grille channel and reattach
the end cap.
5=
A. Backer panel
Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
B
A. Top grille
B. Cabinet side trim
IMPORTANT:
• Install the custom handles prior to installing the panels on the
refrigerator. For more information on KitchenAid custom
handle selection, refer to the KitchenAid Catalog, visit
www.kitchenaid.com, or call 1-800-442-9991. In Canada,
visit www.KitchenAid.ca, or call 1-800-807-6777.
• Create custom door overlay panels according to the
specifications in the "Overlay Series Custom Panels" section.
• KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator for service.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer compartment doors.
3. Remove the handle side and top trims.
IIItlIIIIIIIIIIIIIIItlUtlIIIIIIIIIIItlUtlIIIIIIIIIIttlUtlII
A. Trims
................. _ a
4=
Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
IIIIIIIIIttlUtlIIIIIIIIIIIIIttlUtlIIIIIIIIIIIIIIIIIIIItlIIII
.......... A
A. Panels
5. Reinstall the handle-side and top trims.
6. Remove the protective skin from the screw covers. Slide or
snap the screw covers into the handle trim section.
7. Check refrigerator level and alignment. Adjust if needed.
23