Table of Contents
Advertisement
3.
Remove the screw that holds the blower motor
and carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
CAUTION: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4.
Roll the blower unit 90 ° so that the fan blade
ED
openings are facing toward the front of the
microwave.
Before Roll
SMH1927_XAA_DE68-04108A-01_EN_120725.indd 13
blower mortor screw
Back of
Microwave
After Roll
Back of
Microwave
Step-by-step installation guide
5.
Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6.
Secure the blower unit to the microwave with the
screw.
B2. INSTALLING THE CHARCOAL
FILTER
1.
Remove the screws on the top of the grill using a
#1 Phillips screwdriver.
2.
Open the door.
3.
Remove the grill.
• Push the grill left, and then pull the grill straight
off.
4.
Install the charocal filter. When properly installed,
the wire mesh of the filter should be visible from
the front.
5.
Reinstall the grille and the screws.
6.
Close the door.
13
Charcoal filter
Insert mesh-side up
2012-07-25
7:54:34
Hide quick links:
Advertisement
Table of Contents
