Door Disassembly - Sharp R930AK - 1.5 CF 900 Watts Convection Sensor Interactive; Charcoal Service Manual

Convection microwave oven

Hide thumbs

Table of Contents

R-930AK

R-930AW

Note: The door on a microwave oven is designed to act as

an electronic seal preventing the leakage of

microwave energy from oven cavity during cook

cycle. This function does not require that door be

airtight, moisture (condensation)-tight or light-tight.

Therefore, occasional appearance of moisture, light

or sensing of gentle warm air movement around

oven door is not abnormal and do not of themselves

indicate a leakage of microwave energy from oven

cavity. If such were the case, your oven could not

be equipped with a vent, the very purpose of which

is to exhaust the vapor-laden air from the oven

cavity.

Remove door assembly, refer to "Door Replacement".

Replacement of door components are as follows:

1. Place door assembly on a soft cloth with latches facing

up.

Note: As the engaging part of choke cover and door panel

are provided at several places, do not force any particular

part.

2. Insert an putty knife (thickness of about 0.5mm) into the

gap between the choke cover and corner portion of door

panel as shown Figure C-6 to free engaging parts.

3. Lift up choke cover.

4. Now choke cover is free from door panel.

RE-INSTALL

DOOR ASSEMBLY

Figure C-5. Door Replacement and adjustment