For some models, you need to apply two FCC labels. Check the old base cover; if it has two FCC labels,
apply both to the new base cover.
2010 LCD unit
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 52
•
"1020 Bottom slot cover" on page 53
•
"1040 Hard disk drive or solid state drive assembly" on page 54
•
"1070 Keyboard" on page 59
•
"1090 Top case assembly" on page 62
• "1130 System board assembly, fan assembly, and backup battery" on page 66
Removal steps of LCD unit
In step
1
, release the antenna cables from the cable guides.
When installing:
• Make sure that the cables are attached to the cable guides firmly.
• When you route the cables, make sure that they are not subjected to any tension. Tension could cause
the cables to be damaged by the cable guides, or a wire to be broken.
72
Hardware Maintenance Manual