Setting The Speaker Mode; Setting The Delay Time - Samsung HTZ210T User Manual

system setup

SETTING THE SPEAKEr MODE

Signal outputs and frequency responses from the speakers will
automatically be adjusted according to your speaker configuration and
whether certain speakers are used or not.
1.
In Stop mode, press the MENU button.
. Press the Cursor % button to move to Audio and then press the
ENTEr button.
. In the SPEAKEr SETUP, press the ENTEr button again.
.
Press the Cursor ,,, button to move to the desired speaker
and then press the ENTEr button.
SL
For C,
~
alternately as follows : SMALL ➞ NONE.
For L and R, the mode is set to SMALL.
~
SMALL : Select this when using the speakers.
~
NONE : Select this when no speaker is connected.
~
d Press the rETUrN button to return to the previous level.
d Press the EXIT button to exit the setup screen.
M
`
Depending on PRO LOGIC and STEREO settings, the speaker mode may vary (see page 51).

SETTING THE DELAY TIME

If the speakers cannot be placed at equal distances from the listening position, you can adjust the delay
time of the audio signals from the center and rear speakers.
1. In Stop mode, press the MENU button.
. Press the Cursor % button to move to Audio and then press the ENTEr button.
. Press the Cursor % button to move to DELAY TIME and then press the ENTEr button.
. Press the Cursor ,,, button to move to the desired speaker and then press the ENTEr button.
5. Press the Cursor , to set the Delay time.
You can set the delay time for C between 00 and 05mSEC and for SL and SR between 00 and 15mSEC.
~
d Press the rETUrN button to return to the previous level.
d Press the EXIT button to exit the setup screen.
DviX (r) registration
Please use the Registration code to register this player with the DivX (R) video on demand format.
To learn more, go to www.divx.com/vod.

, and SR, each time the button is pressed, the mode switches
MOVE ENTER RETURN EXIT
MOVE CHANGE EXIT
RETURN