Setting The Speaker Mode; Setting The Test Tone - Samsung HT-EV100 Instruction Manual

Setting the Speaker Mode

1 2
Press MENU button.
In the Speaker
3 4
Setup, press the
ENTER button again.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note
•
With
mode.
•
With AC-3 and DTS, the delay time is set between 00 and 15mSEC.
•
Depending on PRO LOGIC and STEREO, the speaker mode may vary.
45
Downloaded From TheatreSystem-Manual.com Manuals
Press Cursor
button to move to
'Audio' and then
press ENTER button.
Press Cursor , ,
, buttons to move
to the desired
speaker and then
press ENTER button.
•
For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL NONE.
•
For L and R, the mode is set to SMALL.
(Dolby Pro Logic II), the delay time may be different for each

Setting the Test Tone

1 2
Press MENU button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
When manually testing using the TEST TONE button
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
•
Use this function to check that each speaker is
correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button.
Press Cursor Press Cursor
3
button to move to to move to 'TEST
'Audio' and then TONE' and then press
press ENTER button. ENTER button.
•
The test tone will be sent to L
R RS LS
If the button is pressed again at this
time, the test tone will stop.
L: Front Speaker (L) C: Center Speaker
R: Front Speaker (R) LS: Rear Speaker (L)
Multi-Channel Pro Logic Mode
Start
button
C
SW in that order.
SW: Subwoofer
RS: Rear Speaker (R)
46