Installing The Network Teaming And Configuration Utility; Using Hp Software Update Manager (Hpsum); Configuring Array Controllers - HP ML310 - ProLiant - G2 User Manual

Installing the Network Teaming and Configuration
Utility
The CPQTEAM Utility enables multiple NICs to be teamed together. You must run the HP Software update
manager to install the CPQTEAM utility.
During the CPQTEAM software installation process, a message might appear, stating that the
CPQTEAM.DLL file is needed. A default path appears in the message box. Click OK to accept the path
and continue with the installation.

Using HP Software Update Manager (HPSUM)

HPSUM is installed when the server software is installed. This software contains device drivers and utilities
that take advantage of specific capabilities offered with ProLiant server products. These drivers are
provided for use with ProLiant hardware only. For more information, see the PSP for the operating system
located on the disk drive in the C:\hpsum directory.
To launch HPSUM:
Click Start, and then select All Programs>Pre-Install Features>ProLiant Support Pack.
1.
Follow the on-screen instructions when the setup program is launched.
2.
To manually launch the setup program:
Click Start>Run.
1.
Enter the following path in the textbox:
2.
C:\HPSUM\SETUPEX.EXE
Click OK.
3.
After the setup program is launched, follow the on-screen instructions.
4.

Configuring array controllers

If an array controller has been purchased with the server, run the online ACU to set up the remaining
physical drives for use.
IMPORTANT:
to interface with the array controller. For the page to display properly, the server IP address
must be included in the trusted sites list. Internet Explorer must be restarted after adding the IP
address to the trusted sites list for the settings to take effect.
Click Start, and select All Programs>HP System Tools>HP Array Configuration Utility.
1.
Select whether you want to enable remote administration when prompted.
2.
Click OK.
3.
When prompted for the Web-Based Management password, enter the credentials for either the local
4.
administrator account or a local user account in the following format:
domain name\login name
Configure the remaining physical drives into logical drives, and run Disk Administrator to partition
5.
and format the additional drive space.
Microsoft® Internet Explorer is required to run the ACU. Internet Explorer is used
Post-installation tasks for HP ProLiant 300 series servers only 21