Safety Guidelines - Westinghouse LVM-47W1 - 47" LCD Flat Panel Display User Manual

Safety Guidelines
CAUTION: The power supply outlet should be located near the HD Monitor and should be easily accessible.
Always use the appropriate AC cord that is certified for your specific country. Some examples are listed below:
USA .................. UL Switzerland ..... SEV
Canada ............. CSA Britain .............. BASE/BS
Germany .......... VDE Japan ............... Electric Appliance Control Act
IMPORTANT NOTICE CONCERNING POWER CORD SELECTION
The specific power cord for this HD Monitor is enclosed and has been selected according to the country of
destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to replace
the original cord set, or if the cord set is not enclosed. The female receptacle of the cord set must meet
IEC-60320 requirements and should look like Figure A1 below:
Figure AI[_ Figure A2@_.
For the United States and Canada
In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL Listed, and CSA Labeled.
For LCD Monitors that are placed on a desk or table, type SVT or SJT cord sets may be used. For LCD
Monitors placed directly on the floor, only SJT type cord sets may be used. The cord set must be selected
according to the current rating for the LCD Monitor. Please consult the table below for the selection criteria for
power cords used in the United States and Canada.
Cord
Type
Size of Conductors in Cord Maximum Current
Rating
of Unit
18 AWG 10 Amps
SJT 16 AWG 12 Amps
14 AWG 12 Amps
18 AWG 10 Amps
SVT
17 AWG 12 Amps
FCC Compliance Statement
This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy, and may
cause harmful interference to radio communications if not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the LCD Monitor and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the Westinghouse Service Center or an experienced radio/Monitor technician for assistance.
FCC Warninq
To assure continued FCC compliance, the user must use a grounded power supply cord and the
provided shielded video interface cable with bonded ferrite cores. If a BNC cable is used, use only a
shielded BNC (5) cable. Also, any unauthorized changes or modifications not expressly approved by
Westinghouse Digital will void the user's authority to operate this device.
4