Table of Contents
Advertisement
9. Troubleshooting & FAQs
9. Troubleshooting & FAQs
9.1 Troubleshooting
This page deals with problems that can be
corrected by a user. If the problem still persists
after you have tried these solutions, contact
Philips customer service representative.
Common Problems
No Picture (Power LED not lit)
v
Make sure the power cord is plugged into
the power outlet and into the back of the
monitor.
v
First, ensure that the power button on the
front of the monitor is in the OFF position,
then press it to the ON position.
No Picture (Power LED is White)
v
Make sure the computer is turned on.
v
Make sure the signal cable is properly
connected to your computer.
v
Make sure the monitor cable has no bent
pins on the connect side. If yes, repair or
replace the cable.
v
The Energy Saving feature may be activated
Screen says
Attention
Check cable connection
v
Make sure the monitor cable is properly
connected to your computer. (Also refer to
the Quick Start Guide).
v
Check to see if the monitor cable has bent
pins.
v
Make sure the computer is turned on.
AUTO button doesn't function
v
The auto function is applicable only in
VGA-Analog mode. If the result is not
satisfactory, you can do manual adjustments
via the OSD menu.
Note
The Auto Function is not applicable in DVI-
Digital mode as it is not necessary.
Visible signs of smoke or sparks
v
Do not perform any troubleshooting steps
v
Disconnect the monitor from mains power
source immediately for safety
v
Contact with Philips customer service
representative immediately.
Imaging Problems
Image is not centered
v
Adjust the image position using the "Auto"
function in OSD Main Controls.
v
Adjust the image position using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
Image vibrates on the screen
v
Check that the signal cable is properly
securely connected to the graphics board
or PC.
Vertical flicker appears
v
Adjust the image using the "Auto" function
in OSD Main Controls.
v
Eliminate the vertical bars using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
Horizontal flicker appears
v
Adjust the image using the "Auto" function
in OSD Main Controls.
35
Hide quick links:
Advertisement
Table of Contents
