Panasonic DP-MC210 Operating Instructions Manual page 64

9. Programmable Features
Feature/Code
Setting the Error Correction
Mode (ECM)
{#}{4}{1}{3}
Setting the connecting tone
{#}{4}{1}{6}
Setting the maximum fax
speed
{#}{4}{1}{8}
Activating the Distinctive
Ring feature
{#}{4}{3}{0}
Setting the ring pattern for fax
(Distinctive Ring feature)
{#}{4}{3}{1}
Setting auto reduction
feature
{#}{4}{3}{2}
Changing the fax activation
code
{#}{4}{3}{4}
64
Selection
This feature is available when the sending / receiving fax machines are ECM
compatible.
{0} "Off": Deactivates this feature.
{1} "On" (default): Fax transmission / reception will be carried out so that the
errors do not occur.
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party's machine.
{0} "Off": Deactivates this feature.
{1} "On" (default): You will hear connecting tones.
Note:
L If the ring back tone continues, the other party's machine may not be a fax
machine or may have run out of paper. Check with the other party.
L The connecting tone volume cannot be adjusted.
{1} "14.4Kbps"
{2} "33.6Kbps" (default)
Note:
L The fax speed maybe lower than the selected speed depending on your
line.
{0} "Off" (default)
{1} "On"
See page 58 for details.
{1} "A"
{2} "B"
{3} "C"
{4} "D"
{5} "B-D" (default)
See page 58 for details.
To receive a fax document that is longer than your recording paper.
{0} "Off": The unit will print received documents at their original size.
{1} "On" (default): The unit will scale received documents to fit your recording
paper.
If you wish to use an extension telephone to receive faxes, activate this feature
and program the activation code.
Important:
L The fax activation code must be different from the code that you
programmed on the answering machine.
{0} "Off"
{1} "On" (default)
1. {Menu} i {#}{4}{3}{4}
2. Press {1} to select "On". i {Set}
3. Enter your code from 2 to 4 digits, using 0–9, {*} and {#}.
L The default code is ";#9".
L Do not enter "0000".
4. {Set} i {Menu}