Power Cord Set Requirements; General Requirements - Compaq 303500-001 - V 900 - 19" CRT Display User Manual

Color Display Values
Red
Green
Blue
White Point (9300 K)
White Point (6500 K)
White Point (5500 K)
Gamma: 2.25
*
Commission International d'Eclairage, 1931 Standard.

Power Cord Set Requirements

The monitor power supply is provided with Automatic Line Switching
(ALS). This feature allows the monitor to operate on input voltages
between 100-120V or 220-240V.
The power cord set (flexible cord or wall plug) received with the
monitor meets the requirements for use in the country where you
purchased the equipment.
Power cord sets must meet the requirements of the country where you
use the monitor. For more information on power cord set requirements,
contact your Compaq authorized dealer, reseller or service provider.

General Requirements

The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet
(1.5 m) and a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable
accredited agency responsible for evaluation in the country where
the power cord set will be used.
3. The power cord set must have a minimum current capacity of
10A and a nominal voltage rating of 125 or 250 volts AC, as
required by each country's power system.
4. The appliance coupler must meet the mechanical configuration of
an EN 60 320/IEC 320 Standard Sheet C13 connector, for mating
with appliance inlet on the rear of the unit.
CIE* Chromaticity Coordinates
x
0.625
0.285
0.150
0.281 (+/- .015)
0.313 (+/- .015)
0.332 (+/- .015)
y
0.340
0.605
0.065
0.311 (+/- .015)
0.329 (+/- .015)
0.348 (+/- .015)
English 1-23