Table of Contents
Advertisement
PS/2 Keyboard and Mouse Support [Auto]
Select any of these settings when PS/2 keyboard and mouse are installed. These settings
only apply when Fast Boot is enabled.
[Auto]
[Full Initialization] For full system control, PS/2 devices will be available during POST at any
[Disabled]
Network Stack Driver Support [Disabled]
[Disabled]
[Enabled]
Next Boot after AC Power Loss [Normal Boot]
[Normal Boot]
[Fast Boot]
2.7.2
Boot Logo Display [Enabled]
[Enabled]
[Disabled]
Boot Logo Size Control [Auto]
[Auto]
[Full screen]
POST Delay Time [3 sec]
This item appears only when you set Boot Logo Display to [Enabled]. This item allows you
to select the desired additional POST wait time to easily enter the BIOS setup. You can only
execute the POST delay time during Normal Boot. The values range from 0 to 10 seconds.
Post Report [5 sec]
This item appears only when you set Boot Logo Display to [Disabled] and allows you to set
the waiting time for the system to display the post report. Configuration options: [1 sec] [2
sec] [3 sec] [4 sec] [5 sec] [6 sec] [7 sec] [8 sec] [9 sec] [10 sec] [Until Press ESC]
2.7.3
Bootup NumLock State [On]
[On]
[Off]
2.7.4
Wait for 'F1' If Error [Enabled]
When this item is set to [Enabled], the system waits for the F1 key to be pressed when error
occurs. Configuration options: [Disabled] [Enabled]
2-30
For a faster POST time, PS/2 devices will only be available when the
system boots up or rebooted when the PS/2 devices have not been
reconnected or changed. If you disconnect or change PS/2 devices before
restarting the system, PS/2 devices will not be available and BIOS setup
program will not be accessible via PS/2 devices.
circumstances. This process will extend POST time.
For the fastest POST time, all PS/2 devices will not be available until your
computer enters the operating system.
Select to skip the network stack driver from loading during POST.
Select to load the network stack driver during POST.
Returns to normal boot on the next boot after AC power loss.
Accelerates the boot speed on the next boot after AC power loss.
Displays the boot logo during POST.
Hides the boot logo during POST.
Alutomatically adjusts the boot logo size for Windows
Maximizes the boot logo size.
Sets the power-on state of the NumLock to [On].
Sets the power-on state of the NumLock to [Off].
requirements.
®
Chapter 2: Getting started
Hide quick links:
Advertisement
Table of Contents
