AEG LAVAMAT 60810 User Information page 20

Problem
E10 appears.
indicator (END)
flashes 1x, at the same
time an acoustic signal
sounds 1x.
(Problems with water
inflow)
The washing machine
vibrates when operating
or is not stable.
Washing has not been
spun.
Water is running out
from under the washing
machine.
Washing water is foam-
ing excessively. At the
end of the washing cy-
cle, the spin stops.
E20 appears.
indicator (END)
flashes 2x, at the same
time an acoustic signal
sounds 2x.
(Problems with water
outflow)
20
Possible cause
Tap turned off.
The filter in the threaded in-
let hose fitting is blocked.
Water tap is furred with
lime scale or is faulty.
The transit packaging has
not been removed.
The screw feet not correctly
adjusted.
Only a few large items of
washing in the drum.
Screw connection on the in-
let hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
Probably too much deter-
gent has been used.
Kink in drain hose.
Maximum pumping height
of 1m exceeded.
Drain pump is blocked.
For sink spigot connections:
The sink spigot is blocked.
Remedy
Turn on the tap.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Check the tap and have it re-
paired, if necessary.
Removing the transit pack-
aging.
Adjust the feet as described
in the installation and con-
nection instructions.
Always load the drum as full
as possible. Mix large and
small items.
Screw the inlet hose on
tightly.
Replace drain hose.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
Straighten the hose.
Please contact the Customer
Care Department.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
Clean the sink spigot.