Table of Contents
Advertisement
2. Press and hold the programme button for approx. 3 seconds.
Programme display 2 will light up and go out after approx. 3 seconds.
The indicator for the programme button will flash.
The indicator for the end of the dishwashing cycle will flash simultane-
ously:
– The number of times that the indicator for the end of the dishwash-
ing cycle flashes corresponds to the hardness setting.
– This sequence of flashes is repeated several times, with a 3 second
pause in between.
3. Pressing the programme button increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
4. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to "1", this switches off the
control indicator for special salt.
1)
in °d
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
below 4
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
8
Water hardness
2)
in mmol/l
Range
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
3,3 - 3,9
2,6 - 3,2
1,9 - 2,5
0,7 - 1,8
I/II
below 0.7
Adjusting the hardness
setting
Manual
IV
1
III
II
0*
I
Number of
flashes
Electronic
3)
10
10
9
8
7
6
5
4*
3
2
1
no salt
necessary
9
8
7
6
5
4
3
2
1
Advertisement
Table of Contents
