Ipv6 Static Route - TP-Link TD-W8970 User Manual

TD-W8970
2. Enter the following data:
Destination IP Address: The Destination IP Address is the address of the network or host
that you want to assign to a static route.
Subnet Mask: The Subnet Mask determines which portion of an IP Address is the network
portion, and which portion is the host portion.
Gateway: Here you should type the Gateway address correctly, and the option for Interface
will adopt the default Gateway address for the Static Route.
Interface: Select the Interface name in the text box, or else, the default Use Interface will be
adopted for the Static Route.
Status: Select Enabled or disabled from the drop-down list.
3. Click Save to save your settings as shown in Figure 4-54.
To modify or delete an existing entry:
Find the desired entry in the table.
1
Click Edit as desired on the Edit column.
2
Click the Enable/ Disabled Selected button to make selected entries enabled/ disabled.
Click the Delete Selected button to delete selected entries.

4.9.3 IPv6 Static Route

Choose "Route Settings"
screen allows you to configure the IPv6 static routes (shown in Figure 4-53). An IPv6 static route is
a pre-determined path that network information must travel to reach a specific host or network.
300Mbps Wireless N Gigabit ADSL2+ Modem Router User Guide
Figure 4-54
"IPv6 Static Route". You can see the IPv6 Static Route screen. This
Figure 4-55
65