Table of Contents
Advertisement
System Devices
The System Devices screen contains parameters involving your hardware devices. It also provides advanced
settings of the system.
The table below describes the parameters in the screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
Internal Touchpad
Infrared Port (FIR)
Parallel Port
Mode
Base I/O address
Interrupt
DMA Channel
40
Description
Determines whether or not to disable the internal
pointing device as the PS/2 mouse is connected.
Enables, disables or auto detects the infrared port.
Enables, disables or auto detects the parallel port.
Sets the operation mode of the parallel port.
Sets the I/O address of the parallel port. This
parameter is enabled only if Mode is set to ECP or
Bi-directional.
Sets the interrupt request of the parallel port.
Sets a DMA channel for the printer to operate in
ECP mode. This parameter is enabled only if Mode
is set to ECP.
Options
Both
or Auto
Enabled
/Disabled/Auto
Enabled
/Disabled/Auto
ECP
, EPP, Normal or Bi-directional
378h/
278h
IRQ7
or IRQ5
DMA3
or DMA1
Chapter 2
Advertisement
Table of Contents
