What To Do, If; Error Messages Are Displayed - AEG FAVORIT 65050 i User Instructions

What to do, if ...

Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call an engineer to resolve a of fault
listed here, or to repair a fault caused by incorrect use or installation, a
charge will be made even if the appliance is in guarantee.

...Error messages are displayed.

If any of the indicators in the control panel, as listed in the table below,
are flashing or are illuminated, you can probably rectify the fault your-
self.
Malfunction
The programme indicator for
the selected programme is
flashing. The
continuously illuminated,
Å 10
error code
in the multi-display: there is
no water running into the
dishwasher.
The programme indicator for
the selected programme is
flashing, error code
displayed in the multi-display.
Å 30
Error code
in the multi-display.
The tap is blocked or furred
with lime-scale.
The tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
^
indicator is
is displayed
Filters in the base of the
washing compartment are
blocked.
The water inlet hose has not
been correctly laid.
The siphon is blocked.
The water drain hose has
Å 20
is
not been correctly laid.
The leak prevention system
is displayed
has been triggered.
Possible cause
Operating Instructions
Remedy
Clean the tap.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
selected programme,
then cancel the pro-
gramme by pressing
RESET (see chapter:
"Starting a pro-
gramme"); clean out the
filters (see chapter:
"Cleaning the filters").
Check hose installation.
Clean out siphon.
Check hose installation.
Turn off the tap and
contact your local Serv-
ice Force Centre.
33