There Are Problems With The Operation Of The Dishwasher; The Wash Results Are Not Satisfactory - AEG FAVORIT 65050 i User Instructions

Operating Instructions
After rectifying an Å 10 or Å 20 error, press the button for the pro-
gramme that has been started. The programme will continue.
If the fault is displayed again, please contact your local Service Force
Centre.
For all other errors displayed, please contact your local Service Force
3
Centre, stating the error code.
...there are problems with the operation of the dish-
washer.
Symptom
The programme does
not start.
Rust spots are visible in
the washing compart-
ment.
There is a whistling
noise during washing.

...the wash results are not satisfactory.

The dishes are still dirty.
– The wrong wash programme was selected.
– The dishes were loaded is such a way that the wash waster did not
reach all items. The baskets for the dishes must not be overloaded.
34
Possible Cause
The door of the dishwasher is
not closed properly.
Mains plug is not plugged in. Insert mains plug.
House fuse is defective.
A start delay is selected.
The washing compartment is
made from rust-free stainless
steel. Rust spots in the wash-
ing compartment are due to
rust particles from external
sources (rust particles from
water pipes, pans, cutlery,
etc.). Remove such spots with
one of the stainless steel
cleaners that are generally
available on the market.
The whistling is not a cause
for concern.
Solution
Shut the door.
Replace fuse.
If dishes are to be washed
immediately cancel delay
start timer.
Only wash cutlery and dishes
that are suitable for dish-
washer use.
Close the lid of the special
salt container securely.
Use a different brand of
detergent.