Specifications - Sony UP-897MD Instructions For Use Manual

3
Clean the platen roller gently with a damp clothe
soaked in water and a mild detergent.
Platen roller
Notes
• After the surface of the platen roller wiped has
been dried completely, turn the platen roller to
clean another portion.
• Do not turn the platen roller with hands. Use the
FEED button to turn it. To clean another part of
the surface of the platen roller, go to the next step.
4
Press and hold down the FEED button so that the
platen roller turns automatically. Release the FEED
button when the surface of the platen roller to be
cleaned appears.
Be careful so that you have your fingers caught
in the turning platen roller.
Notes
• The platen roller is turning while you are pressing
the FEED button. Be careful so that you have
your fingers caught in the turning platen roller.
• Be sure to start cleaning only after the platen
roller has stopped completely.
5
Repeat steps 3 and 4 until the platen roller becomes
clean.
6
After the platen roller has been dried completely,
close the door by pushing it.

Specifications

Power requirement
100 to 240 V AC, 50/60 Hz
Input current 1.5 A to 0.8 A
Operating temperature
5 °C to 35 °C (41 °F to 95 °F)
Operating humidity
20 % to 80 %
Storage and transport temperature
–20 °C to +60 °C (–4 °F to +140 °F)
Storage and transport humidity
20 % to 90 %
154 × 88 × 240 mm (w/h/d)
Dimensions
(6 1/6 × 3 1/2 × 9 1/2 inches)
Mass 2.6 kg (5 lb 11 oz) (printer only)
Thermal head Thin-film thermal head, 1280 dots
Gradation 256-level gradation (8-bit)
Resolution (when "SC:WD1" is selected from "SCAN")
EIA: 1210 × 490 dots
CCIR: 1210 × 582 dots
Picture size (when "SC:WD1" or "SC:NOR" is selected
from "SCAN")
When "S:STD" is selected from
"SIDE"
EIA: 94 × 73 mm
CCIR: 94 × 71 mm
When "S:SIDE" is selected from
"SIDE"
EIA: 124 × 96 mm
CCIR: 127 × 96 mm
Printing speed About 2 sec./image (at standard
setting) (when "SP:HI" is selected
from "SPEED")
About 3.3 sec./image (at standard
setting) when "SP:NOR" is selected
from "SPEED")
Picture memory 10 frames (800 k × 8 bits for one frame)
Input connector VIDEO IN (BNC type)
EIA or CCIR composite video signals
1.0 Vp-p, 75 ohms/high-impedance
(EIA/CCIR automatically
discriminated)
Output connector
VIDEO OUT (BNC type)
EIA or CCIR composite video signals
1.0 Vp-p, 75 ohm loop-through/EE
switchable
REMOTE connector (stereo mini jack)
1 GND
49
Specifications