Table of Contents
Advertisement
MOUNTING HOLES
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
MAGNET
CLIP
Figure 3. Mounting Holes
Mounting the Module in an Advent Cabinet
1.
Remove panel AC power and disconnect the backup
battery(s).
2.
Remove the module cover and set it aside (Figure 2).
3.
Turn the module upside down and line up the holes on
the back-plate at the desired location (Figure 4).
4.
Secure the back-plate to the cabinet using three ¼-inch
#6-32 self-tapping screws (not included).
ROOM FOR 3RD
MODULE
9712G11A.DSF
Figure 4. Mounting Module in Advent Cabinet
SuperBus® 2000 4-Relay Output Module
REED SWITCH
9710G02B.DSF
HOLDER
PANEL CABINET
(COVER NOT SHOWN)
MOUNT WITH
SELF TAPPING
SCREWS
MOUNTED MODULE
Mounting the Module in a Concord Cabinet
1.
Remove AC panel power and disconnect the backup
battery.
2.
Remove and discard the module cover (Figure 2).
3.
Insert a support standoff as shown in Figure 5 (sup-
plied with panel) into the panel circuit board.
SUPPORT STANDOFF
PANEL
END
Figure 5. Support Standoff
4.
Slide the module back-plate onto the two clips located
on the top-left corner or center of the cabinet
(Figure 6).
Note
The two mounting clips in the top-right corner of the
cabinet are designated for a receiver module, but if a
receiver module is not being used, the mounting clips
may be used for the 4-Relay Output Module.
5.
Push the lower-right corner of the module onto the
support standoff (see detail in Figure 6).
6.
Gently press the module up and onto the cabinet side
tab.
USABLE MOUNTING
CLIPS (6)
CARD ON
MODULE
BACK-PLATES
SIDE TAB
9712G08A.DSF
Figure 6. Mounting Module in Concord Cabinet
Installation
MODULE
END
8573g64A.DSF
PANEL CABINET
(COVER NOT SHOWN)
DETAIL
SUPPORT STANDOFF
(Included with Concord
panel accessory package)
3
Advertisement
Table of Contents
