®
SuperBus
4-Relay Output Module
Document Number: 466-1608 Rev. B
November 2000
Product Summary
Each SuperBus 2000 4-Relay Output module adds four pro-
grammable relay outputs to a compatible panel.
Examples of module uses include:
Turning on a CCTV camera during a burglary alarm.
Turning on exit lights during a fire alarm.
Activating backup cellular phones or long-range radios
if primary communications are inoperable.
Each module comes complete with mounting hardware.
Power for the module is provided by the panel.
®
Advent
panels can be expanded to a total of 124 (24 pre-
programmed) output points.
®
™
UltraGard
and Concord
panels can be expanded to a total
of 32 output points.
For additional security, the plastic case accommodates a
magnetic reed switch to provide tamper protection. Simply
connect a UL listed reed switch to the module built-in zone
input or to one of the fire/security panel hardwire input
zones.
SuperBus 2000 vs. SuperBus
SuperBus 2000 panels have the ability to auto-address mod-
ule unit numbers. When the panel is initially powered up,
the panel automatically reads the unique SuperBus 2000
device ID number and assigns a unit number to the module.
This eliminates manually setting DIP switches and the
chance of identical unit number conflicts.
SuperBus 2000 Panels
Advent
Concord (software versions 2.0 and later)
SuperBus panels communicate with SuperBus 2000 mod-
ules but require the module unit number to first be set man-
ually with DIP switches.
SuperBus Panels
UltraGard
Concord (software versions 1.0–1.6)
SuperBus® 2000 4-Relay Output Module
2000
Installation Instructions
Module Components
Figure 1 shows the main module components and Table 1
describes them.
Figure 1. Module Circuit Board Components
Table 1: Module Component Descriptions
Component
Unit Number DIP
Used for manually setting module unit
Switches
number (SuperBus panels).
BUS LED (Red)
Flashes to indicate normal
communication with the panel.
POWER LED
Indicates module power status.
(Green)
Output Relays
Form C (dry contact) output relays rated
4A @ 24VDC, 4A @ 24VAC, 1A @
70VAC maximum.
SuperBus 2000
Identifies the unique device ID
Device ID Number
(SuperBus 2000).
Label
Software Version
Identifies the installed software version.
Label
Wiring Terminals
Used for power, bus, and output wiring
connections. All terminals are Class 2
power limited.
ITI Part No. 60-770
8557109A.DS4
UNIT NUMBER
DIP SWITCHES
BUS STATUS LED
(RED)
POWER LED
(GREEN)
OUTPUT RELAYS (4)
SOFTWARE
VERSION LABEL
SUPERBUS 2000
DEVICE ID
NUMBER LABEL
WIRING
TERMINALS
9710G01A.DSF
Function
1