About Memory - LifeSource UA-767 Plus Instruction Manual

ABOUT MEMORY

This monitor automatically stores up to thirty (30) blood pressure and pulse
measurements in memory. Measurements stored in memory are assigned an
index number in the order of the newest to the oldest. The oldest reading dis-
plays as "n01". The M symbol in the upper left corner of the display screen
indicates that you are viewing a previous measurement stored in memory.
To retrieve readings, follow these simple steps:
1.
When the display screen is blank, press and quickly release
the Memory ("M") button. You will see the average blood
pressure reading displayed. Press and quickly release the
Memory button again. You will see the index number of the
most recent reading followed by the measurement.
2.
If you want to retrieve other measurements in memory,
press and release the Memory button repeatedly until the
desired index number is reached (e.g. n04). The measure-
ment will then be displayed.
3.
The display will shut off automatically a few seconds after
the readings are displayed.
To clear the measurement history from memory, press and hold the Memory
button for at least five seconds while the display screen is blank. Release the
button when you see the M symbol flash and disappear in the upper left
hand corner of the display. This indicates that the memory has been cleared.
If there are no measurements stored in memory, you will see two 0s displayed
vertically followed by a blinking "A00".
NOTE: Stored measurements will be lost if batteries become low or are
removed.
E-10 LifeSource Health Line (Toll-Free): 1-888-726-9966