Table of Contents
Advertisement
Fitting the stability bracket
It is recommended that if the appliance is to
be installed with a flexible supply pipe, a
stability bracket be fitted and is available
from your supplier (see Important Safety
Requirements). These instructions should
be read in conjunction with any leaflet
packed with the stability bracket.
1. Place the appliance in its intended
position and level appliance.
2. Mark off 250mm from the left hand side
of the appliance as shown in dimension
' A' , Fig 3a. This is the centre line of the
fixing bracket.
3. Draw a line from the front edge of the
feet (see Fig.3a) and remove appliance
from its position. Mark off dimension ' B'
(see Fig.3a) back from this line on the
centre line of the bracket to locate the
front edge of the lower bracket.
lower bracket (with two fixing holes) to
the floor then measure the height from
floor level to engagement edge on back
of appliance, dimension ' C' of Fig. 3b.
4. Assemble upper bracket to lower bracket
so that the underside of bracket is
dimension ' C' + 3mm above floor level.
(See Fig. 3b)
Reposition appliance and check that top
bracket engages into appliance back as
shown in Fig. 3b.
The battery
1. The battery is located on the left hand
side of the front plinth.
2. To gain assess to the battery, open the
main oven door and lift up the battery
holder lid.
3. Fit the new battery ensuring (+) terminal
is next to the (+) sign on the battery.
See Fig. 4.
4. Close the lid of the battery holder.
Fig.3a.
Fix
20mm
100mm
(A)
250mm
Fig.4.
(C)
Fig.3b.
35
Advertisement
Table of Contents
