Panasonic TXL42D25 Operating Instructions Manual page 101

Problem
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Cannot connect to the network
Cannot select the file during
DLNA operations
Cannot operate VIERA CAST
The TV does not switch On
The TV goes into Standby mode
The remote control does not work
or is intermittent
Parts of the TV become hot
The LCD panel moves slightly
when it is pushed with a finger
Clattered sound might be heard
Overcurrent error message
appears
An error message appears
●
Set the sound setting of the connected equipment to
"2ch L.PCM".
●
Check the "HDMI1 / 2 / 3 / 4 Input" setting in the Sound Menu. (p. 33
●
If digital sound connection has a problem, select analogue sound
connection. (p. 97)
●
Check the HDMI cable is connected properly. (p. 92)
●
Turn the TV and equipment Off, then turn them On again.
●
Check an input signal from the equipment. (p. 97)
●
Check the output resolution of the equipment.
●
Use equipment compliant with EIA/CEA-861/861B.
●
Check the LAN cable or Wireless LAN Adaptor is connected
properly. (p. 75)
●
Check the connections and settings. (p. 75 - 79)
●
Check the network equipment and network environment.
●
The router may not be set to issue IP address automatically. If the
network administrator prefers to allocate an IP address, set an IP
address manually. (p. 77)
●
The router may be using MAC address filtering (security setting).
Confirm the MAC Address of this TV (p. 76) and set the router to be
able to use it.
●
If the problem persists, consult your Internet Service Provider or
telecommunications company.
●
Is media server of the connected equipment prepared? (p. 74)
●
Check applicable data format. (p. 74)
●
Check the connections and settings. (p. 75 - 79)
●
The server or connected line might be busy now.
●
Press and hold the standby On / Off switch on the remote control
for about 1 second if Power LED is red.
●
Check the mains lead is plugged into the socket.
●
The fuse in the mains plug may have blown. Replace it with one of
an identical rating (p. 4).
●
Auto power standby function is activated. (p. 9)
●
The TV enters Standby mode about 30 mins. after analogue
broadcast ends.
●
Are the batteries installed correctly? (p. 8)
●
Has the TV been switched On?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the front of the TV (within about
7 m and a 30 degree angle of the front of the TV).
●
Situate the TV so that sunshine or other sources of bright light do
not shine on the TV's remote control signal receiver.
●
Temperature rises of parts of the front, top and rear panels will not
pose any problems in terms of performance or quality of the TV.
●
There is some flexibility around the panel to prevent damage to the
panel.
●
The panel might move slightly when it is pushed with a finger, and
clattered sound might be heard. This is not a malfunction.
●
The connected USB device might cause this error. Remove the
device and turn the TV Off with Mains power On / Off switch, then
turn it On again.
●
Check if foreign objects are inside the USB port.
●
Follow the message's instructions.
●
If the problem persists, contact your local Panasonic dealer or the
authorized Service Centre.
Actions
)
101