Hdmi (High Definition Multimedia Interface); Step : 2 Remote Control Battery Installation - Sanyo CE42LM4WPN-NA - CE - 42" LCD Flat Panel Display Instruction Manual

Step : 1 Connections (Essential)
REMOVE TERMINAL COVER AS INDICATED BELOW.
Security Fixing point
CONNECT THE DISPLAY UNIT TO VGA. BNC.AND
PERITEL SCART CONNECTOR AS BELOW.
TERMINAL COVER MUST BE REPLACED WITH CABLE EXITS AS
INDICATED IN THE SKETCH ABOVE.
Security fixing point
Wall mount
fixing positions
Connect the LCD monitor to VGA, and Scart connector as required.
1. Connect the in-line power connector to the connector attached to
the LCD monitor as shown above.
2. Connect the correct power cord of the LCD monitor to a wall outlet.
As this product does not have a power On/Off switch, please
ensure your mains plug is easily accessible.
The LCD monitor is prepared for a power voltage AC100 ~240V,
60Hz. To completely switch off the mains, or when the LCD
monitor is not to be used for an extended period of time, it is
advisable to disconnect the power cord from the power outlet or
disconnect the power coupler.
3.
Warning: To prevent injury, the unit must be securely attached to
the wall in accordance with the installation instructions.
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
4
INST
INST
PJ-Net
Cable entry
PJ Net box
HDMI
AV2 audio
IN
Switch Audio monitor
Out
RS232C
Services Serial ports
IN/ Out
AV3 IN/Out
BNC
AV2 IN/ Out
BNC
In-line connector
ALLA TION
ALLA TION
1.

HDMI (High Definition Multimedia Interface)

This monitor has an HDMI connector. When connected to the HDMI
source and HDMI is selected using the remote control, there is a short
time period before the picture appears at a much higher resolution.
This connection is located at the back of the monitor next to the aerial
socket.
Cable entry
2. Y,Pb,Pr connection (AV2)
This LCD monitor has a choice of Y, Pb, Pr or RGB , H/V connections
You can connect your DVD player to the Y, Pb, Pr terminals instead
of using a scart lead. This can support high definition in analogue
component form. RGB, H/V can be used as a PC input via the BNC
terminal.
3. PC connection
This display unit has a PC connector. You can connect a PC to the
Display unit and use it as a monitor (see page 7).
To switch between AV1, RGB, AV2 RGB H/V or Y, Pb, Pr, AV3, HDMI
or PC mode press the TV/AV switch on your remote control
repeatedly or press and hold the the TV/AV button for a few seconds
and selection menu will appear on screen use the e or d buttons to
select the correct mode.
.
4 RS232C IN/OUT: Is an input for external commands to control the
monitor (see page 8). Use the switch to change between RS232/ PJ
net
5.
PJ Net IN/OUT: Has the ability for PJ-NET to be connected to
control the monitor using a network.

Step : 2 Remote control battery installation

Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.
Serial
Port-IN
Serial port
PJ-net
Service
Serial
Port-OUT
Peritel (Scart)