Fused Plug - Hunter 90400 Owner's Manual

This plug is a safety feature. It contains
a safety device (fuse) that should
not be removed. Discard product if
the attachment plug is damaged. To
reduce the risk of fire, electric shock
and personal injury, DO NOT remove,
replace, repair or tamper with the
originally supplied plug. If the fan does
not function properly, it may be due to the
safety device incorporated in this plug.
If the fuse fails, it is generally due
to a short circuit or circuit overload.
Replace the fuse as per the instructions
below. If the replacement fuse
fails, immediately unplug the unit
and contact our technical support
department for assistance.
Fuse Replacement:
1. To replace the fuse, first turn the
unit it off and unplug it from the wall.
Locate the door on top of the plug.
Figure 1.
2. Slide the door on top of the plug
towards the blades. Figure 2.
3. Carefully remove the fuse from
the clips holding it on the top and
bottom. Figure 3.
Warning! Electrical Hazard! Only
replace with a fuse type and rating
matching what was removed from the
product.
4. Gently push the fuse back into the
pins that will hold it in place.
Note: If the fuse is not seated properly,
the unit will not function.
5. Slide the door back over the fuse
box in the plug.
6. Plug the fan back in and resume
use.
©2011 Hunter Fan Co.

FUSED PLUG

5
Figure 1
Figure 2
Figure 3
44826-01 20111014