Answering System Settings; Answer On/Off - AT&T EL52309 - DECT 6.0 User Manual

Handset settings

Answering system settings

Use the answering system menu to turn the answering system on or off,
record your announcement (greeting), change the number of rings, remote
access code and message alert tone.
1. When the handset is in idle mode, press MENU/
menu.
2. Press MENU/
3. Press CID or DIR
SELECT.
MENU/

Answer on/off

Unless you change it, the answering system is on and ready to record
messages. You can turn the answering system off, but if you do so, the
answering system does not answer calls and record incoming messages.
To turn the answering system on or off from a handset:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press /SELECT again.
MENU
3. Press CID or DIR
press /SELECT.
MENU
4. Press /SELECT again to select >ANSWER ON/OFF.
MENU
5. Press CID or DIR
press /SELECT to confirm the setting. A confirmation
MENU
tone sounds.
If the answering system is on, the ANS ON icon displays on
the handset screen.
NOTE: If the answering system is off and there is an incoming call, the system
answers after 10 rings and announce to the caller, "Please enter your remote access
code." For more information about remote access codes, see pages 43-44.
again.
SELECT
to scroll to >ANS SYS SETUP, then press
to scroll to >ANS SYS SETUP, then
to select between ON and OFF, then
SELECT
SELECT
14
to enter the main
to
?BOT!TZT!TFUVQ
QMBZ!NTHT
?BOTXFS!PO0PGG
BOOPVODFNFOU
BOTXFS!PO0PGG
PO