Answering System; Answering System Settings; Announcement - AT&T BL102-4S Complete User's Manual

Answering system

Answering system settings

Use the answering system menu of a system handset
to set up the announcement message, turn on or off
the answering system or message alert tone, activate
call screening, or change the number of rings, or remote
access code. If you turn off the answering system and you
change any setting in the answering system setup menu, the
answering system automatically turns on again.
1. When the handset is in idle mode, press MENU/
main menu.
2. Press q or p
CID

Announcement

Your outgoing announcement plays when calls are answered by the
answering system.
The telephone has a default outgoing announcement, "Hello. Please leave a
message after the tone." You can use this announcement, or record your own.
You can record an announcement up to 90 seconds. The system does not
record any announcement shorter than two seconds.
To record a new outgoing announcement:
1. When the handset is in idle mode, press MENU/
2. Press q or p
CID
/SELECT.
MENU
3. Press /SELECT again to select Announcement.
MENU
4. The handset displays Play [2] Del [3] Rec [7] and it
announces, "To play, press 2. To record, press 7." Press 7 to
record. The handset announces, "Record after the tone.
Press 5 when you are done."
5. After the tone, speak towards the handset or telephone base microphone.
Press 5 to end recording. The newly recorded announcement automatically
plays.
To listen to the recorded announcement again on the handset, wait after
playback has completed, then press 2.
To reset your outgoing announcement:
1. When the handset is in idle mode, press MENU/
2. Press q or p
CID
/SELECT.
MENU
/SELECT again to select Announcement.
3. Press
MENU
to scroll to Answering sys, then press
DIR
to scroll to Answering sys, then press
DIR
to scroll to Answering sys, then press
DIR
SELECT
SELECT
SELECT
72
Play messages
ECO
to enter the
/SELECT.
MENU
to enter the main menu.
Announcement
ECO
to enter the main menu.