Detaching and Attaching the Protective Panel
The LCD panel is covered by a protective panel to protect it from damage during transportation. Remove the
protective panel before use.
Protective
panel screw
• The illustration shows an example for BT-L2150P/
2150E.
indicates screws found only on BT-L2150P/
2150E (not present on BT-L1500P/1500E)
26
Groove
Detaching the panel
1. Unscrew the protective panel screws (10 screws
for BT-L2150P/2150E, 8 for BT-L1500P/1500E)
using a Phillips screwdriver while supporting the
protective panel with your hand.
2. Detach the protective panel.
• After detaching, please store the protective panel and
the protective panel screws.
Attaching the panel
Verify the top and bottom of the protective panel before
attaching.
1. Align the screw holes on the protective panel
with those on the unit.
• Fit the protective panel into the groove on the unit.
2. Using a Phillips screwdriver, screw the
protective panel screws (10 screws for BT-
L2150P/2150E, 8 for BT-L1500P/1500E) to screw
the protective panel to the unit.
• The protective panel may crack if it is screwed too
tight. (Screwing torque: Tighten to about 30 N cm or
less)