Cisco 2501 - Router - EN Configuration Manual page 16

Configuring the Access Server
Entering the Asynchronous Interface Addresses
After the asynchronous lines have been configured and the routing protocols have been
selected, enter the IP addresses for each asynchronous interface.
For information on asynchronous protocols, see the section "Asynchronous Protocols" in
the appendix "Internetworking Primer," and for information on IP addressing, see the
section "Desktop Protocols" in the appendix "Internetworking Primer."
Step 1
4-16 Cisco 2500 Series Access Server User Guide
Configure IP unnumbered on this interface? [no]: yes
IP address for this interface: 172.16.74.2
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 4
AppleTalk ending cable range [3]: 4
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [2]: B002
Enter the IP address for each of the asynchronous interfaces on the access server:
Configuring interface Async1:
Default client IP address for this interface [none]: 172.16.72.11
Configuring interface Async2:
Default client IP address for this interface [172.16.72.12]:
Configuring interface Async3:
Default client IP address for this interface [172.16.72.13]:
Configuring interface Async4:
Default client IP address for this interface [172.16.72.14]:
Configuring interface Async5:
Default client IP address for this interface [172.16.72.15]: