Configuring The Global Parameters - Cisco 2501 - Router - EN Configuration Manual

Once the access server has determined that AutoInstall is not configured, it will default to
the setup facility. If the serial (WAN) cable is not connected, the access server will boot
from Flash memory and go into the setup facility.
Note
the command setup.

Configuring the Global Parameters

When you first start the setup program you must configure the global parameters. The
global parameters are used for controlling system-wide settings. Use the following
procedure to enter the global parameters:
Step 1
Step 2
You can run the setup facility any time you are at the enable prompt (#) by entering
Connect a console terminal by following the instructions in the section
"Connecting the Console Terminal and Modem" in the chapter "Installing the
Cisco 2500 Series Access Server" and then boot the access server to the EXEC
prompt (Router>).
When you have booted from Flash memory, the following information will appear
after about 30 seconds. When you see this information displayed, you have
successfully booted your access server:
System Bootstrap, Version 4.14(8), SOFTWARE
Copyright (c) 1986-1995 by cisco Systems
2500 processor with 16384 Kbytes of main memory
Loading igs-c-l.110-0.7 at 0x3000040, size = 3865444 bytes [OK]
F3: 3779532+85880+173868 at 0x3000060
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Configuring the Access Server
Configuring the Cisco 2500 Series Access Server 4-9