Cisco 1603R Quick Start Manual page 5

Install the Router (continued).
B. Install the WAN interface card.
Look for a WAN interface card in the slot on the right-rear of the router, just above the slot labeled FLASH PC
CARD. (There is no WAN interface card installed if there is a metal plate over the slot.) If the card is already
installed, connect the card to your WAN line according to the instructions that came with the card. To install a
card, follow the instructions below.
Note: You must provide a Phillips
screwdriver for this step.
Step 1
Turn the power OFF by putting
the power switch in the O position.
Step 2
Remove the thumbscrews that
hold the slot cover in place.
Step 3
Remove the metal plate that
covers the card slot.
Step 4
Hold the card by the edges and
line it up with the guide on the card slot.
Step 5
Insert the card into the slot and
push in until it is firmly seated in the
connector and the card front panel is flush
with the router rear panel.
Step 6
Use the Phillips screwdriver to
tighten the screws that are in the card.
Step 7
Connect the correct cable to the
card according the instructions that came
with the card.
Step 8
Turn the power ON by putting
the power switch in the | position.
5