Cisco 1603R Quick Start Manual page 4

Install the Router (continued).
A. Connect the router to the local network.
Connect the router to your local Ethernet network in
one of three ways:
Option 1:
Connect the ETHERNET Ø 10BASET
port to an Ethernet hub or switch.
Option 2:
Connect the ETHERNET Ø AUI port to
an Ethernet transceiver.
Option 3:
Connect the ETHERNET Ø 10BASET
port to your PC.
Option 1
You must provide the Ethernet hub or switch and the
RJ-45-to-RJ-45 cable required for this connection.
Connect one end of the cable to the yellow
ETHERNET Ø 10BASET port.and the other end to
a network port on the 10BaseT hub or switch.
4
LNK LED
Option 2
You must provide the transceiver and AUI cable for
this connection. If the transceiver that you are using
connects directly to the router, you do not need the
cable.
Connect one end of the Ethernet transceiver to the
yellow ETHERNET Ø AUI port and the other end
to the Ethernet network.
Option 3
You must provide an Ethernet crossover cable for
this connection.
Connect one end of the crossover cable to the yellow
ETHERNET Ø 10BASET port and the other end to
the Ethernet connector on the back of your
computer.