Zipper Foot - Brother PQ-1300 Operation Manual

Basic Sewing (3)
Note
Make sure power is off before changing feet.

Zipper Foot

1 Attach zipper foot.
2 Turn hand wheel to lower needle
and adjust position of foot to
needle.
3 Line up zipper to the section of
fabric it will be attached to, and
mark the base of the opening on
the fabric. It should be set
approximately .5 centimeters
below zip stop.
4 Fold hem about .2 cm from mark,
and make a mark along the edge.
A
Slide
Base of
Stop
Opening
0.5cm
0.2cm
5 Sew zipper onto fabric along
mark.
6 Line up folded seam to stitches.
7 Change position of zipper foot.
8 Turn hand wheel to lower needle
and make sure the needle and
position of the foot are lined up
properly.
9 Baste zipper onto fabric and sew
along edge with fabric right side
up.
Reinforce base of opening by
sewing over it twice.
If the zipper slide gets in the way,
lower the needle all the way
through the fabric, lift the foot,and
move the slider out of the way.
B
15