Compaq ProLiant DL380 - G2 Server Service Update Manual page 11

Compaq ProLiant DL380 G2 Service Update
Step
5. Disconnect all remaining cables on the server rear panel.
Remove and replace the access panel
CAUTION: Do not operate the server for extended periods without the access panel. Operating
the server without the access panel results in improper airflow and improper cooling that can lead
to thermal damage.
Step
Extend or remove the server from the rack. See the "Preparation Procedures" section in this
1.
chapter.
Flip up the hood latch handle
2.
Turn the handle one-half turn counter-clockwise
3.
upward.
Slide the access panel toward the rear of the unit about 1.25 cm (0.5 inch) and lift to
4.
remove the panel.
Rev. 1.0
Action
Action
.
. When the latch disengages, it extends
11
Page 11 of 17